Cressida L6-3.0L DOHC (7M-GE) (1989)
7. CHECK PISTON STROKE OF FORWARD CLUTCH
Using SST and a dial indicator, measure the forward clutch piston stroke applying and releasing the compressed air (4 - 8 kg/sq.cm, 57 - 114 psi
or 392 - 785 kPa) as shown.
SST 09350-30020 (09350-06120)
Piston stroke:
7M-GE 3.42-3.93 mm (0.1346 - 0.1547 in.)
7M-GTE 3.73-4.59 mm (0.1469 - 0.1807 in.)
If the piston stroke is less than the limit, parts may have been assembled incorrectly, check and reassemble again.
8. INSTALL DIRECT CLUTCH ASSEMBLY TO FORWARD CLUTCH ASSEMBLY
a. Make sure that the thrust washer is installed to the direct clutch drum.
b. Align the flukes of discs in the direct clutch.
c. Install the direct clutch assembly onto the forward clutch assembly.
d. Check that the distance from the direct clutch end to the forward clutch end is 71.2 mm (2.803 in.).
If the distance is less than the above value, parts may have been assembled incorrectly, check and reassemble again.