Cressida L6-3.0L DOHC (7M-GE) (1989)
/Page-784002.png)
Remove the two oil seal rings.
3. REMOVE STATOR SHAFT
Remove the thirteen bolts, and then remove the stator shaft from the oil pump body.
4. REMOVE OIL PUMP DRIVE GEAR AND DRIVEN GEAR
INSPECTION OF OIL PUMP
1. CHECK OIL PUMP BODY BUSHING
Using a dial indicator, measure the inside diameter of the oil pump body bushing.
Maximum inside diameter: 38.19 mm (1.5035 in.)
If the inside diameter is greater than the maximum, replace the oil pump body.
2. CHECK STATOR SHAFT BUSHING
