FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
Front Door Window Glass Weatherstrip: Service and Repair
Installation
EXTERIOR: FRONT DOOR GLASS WEATHERSTRIP: INSTALLATION
INSTALLATION
HINT: The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
1. INSTALL FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY
(a) Engage the 8 claws and install a new front door glass outer weatherstrip.
(b) Remove the protective tape.
2. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY
(a) Install the outer rear view mirror with the 3 bolts.
Torque: 8.0 Nm (82 kgf-cm, 71 in-lbf)
(b) Connect the connector.
3. INSTALL FRONT DOOR NO. 2 SERVICE HOLE COVER
HINT: Use the same procedure as for the RH side See: Service and Repair/Reassembly.
4. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
HINT: Use the same procedure as for the RH side See: Service and Repair/Reassembly.
5. INSTALL FRONT DOOR ARMREST BASE UPPER PANEL
HINT: Use the same procedure as for the RH side See: Service and Repair/Reassembly.
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 Nm (40 kgf-cm, 35 in-lbf)