FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
Clutch Switch: Service and Repair
Installation
CRUISE CONTROL: CLUTCH SWITCH: INSTALLATION
INSTALLATION
1. INSTALL CLUTCH SWITCH ASSEMBLY
(a) Fully loosen the lock nut of the clutch switch assembly.
(b) Adjust the clutch switch until the threaded portion comes into contact with the cushion. Tighten the lock nut and ensure that the threaded
portion is in contact with the cushion.
Torque: 15 Nm (155 kgf-cm, 11 ft-lbf)
(c) Connect the connector.
2. INSTALL MAIN BODY ECU (DRIVER SIDE J/B)
(a) Install the main body ECU with the 2 nuts.
Torque: 8.4 Nm (86 kgf-cm, 74 in-lbf)
3. INSTALL INSTRUMENT PANEL SIDE BRACKET
(a) Install the instrument panel side bracket with the bolt.
Torque: 8.4 Nm (86 kgf-cm, 74 in-lbf)
4. INSTALL LOWER INSTRUMENT PANEL LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Installation
5. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Installation
6. INSTALL INSTRUMENT PANEL FINISH PLATE See: Lighting and Horns/Key Cylinder Lamp/Service and Repair/Installation
7. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Installation
8. INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal
9. INSTALL COWL SIDE TRIM BOARD LH See: Instrument Panel, Gauges and Warning Indicators/Instrument Cluster / Carrier/Service and