FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
/Page-766019.png)
5. CHECK CAN BUS LINE FOR SHORT TO GND (YAW RATE SENSOR BRANCH WIRE)
(a) Turn the ignition switch OFF.
(b) Disconnect the E64 yaw rate sensor branch wire connector.
NOTICE:
-
Before disconnecting the connector, make a note of where it is connected.
-
Reconnect the connector to its original position.
(c) Measure the resistance.
Result:
NG -- CONNECT CONNECTOR
OK -- Continue to next step.
6. CONNECT CONNECTOR
(a) Reconnect the yaw rate sensor branch wire connector.
NEXT -- Continue to next step.
7. CHECK CAN BUS LINE FOR SHORT TO GND (STEERING ANGLE SENSOR BRANCH WIRE)
(a) Turn the ignition switch OFF.
(b) Disconnect the E65 steering angle sensor branch wire connector.
NOTICE:
-
Before disconnecting the connector, make a note of where it is connected.
-
Reconnect the connector to its original position.
