FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
/Page-1007006.png)
(1) Select "SRMF (SMCF, SA3)" on the intelligent tester.
(2) Depress the brake pedal with stable force, then turn the "SRMF (SMCF, SA3)" on by the intelligent tester.
(3) Release the brake pedal when the solenoid is on, and check that the rear wheels do not rotate by hand.
If the rear wheels rotate, replace the hydraulic brake booster.
HINT:
^
To protect the solenoids, intelligent tester turns off automatically 2 seconds after every solenoid has been turned on.
^
When rotating the wheels fast, the fail-safe function is activated and judgement cannot be made properly. So rotate the wheels as
slowly as possible.
NOTICE: When operating it continuously, set the interval of more than 20 seconds.
(4) When the solenoid is off, check the rear wheels by rotating them by hand.
If the rear wheels stop, replace the hydraulic brake booster.
(n) Inspect rear VSC solenoid (STR) operation (step J).
HINT:
^
ON: Activate STR, depress the brake pedal, and then check that the rear wheels rotate.
^
OFF: Deactivate STR, depress the brake pedal, and then check that the rear wheels do not rotate.
(1) Select "SRMR (SMCR, STR)" on the intelligent tester.
(2) Turn the "SRMR (SMCR, STR) on by the intelligent tester.
(3) When the solenoid is on, check that the rear wheels rotate by hand.
If the rear wheels do not rotate, replace the hydraulic brake booster.
HINT:
^
To protect the solenoids, intelligent tester turns off automatically 2 seconds after every solenoid has been turned on.
^
When rotating the wheels fast, the fail-safe function is activated and judgement cannot be made properly. So rotate the wheels as
slowly as possible.
NOTICE: When operating it continuously, set the interval of more than 20 seconds.
(4) When the "SRMR (SMCR, STR)" is off, depress the brake pedal again and check that the rear wheels do not rotate by hand.
If the rear wheels rotate, replace the hydraulic brake booster.
(o) Inspect rear ABS solenoid (SRRH) operation (step K).
HINT:
^
ON: Activate SRRH, depress the brake pedal, and then check that the right rear wheel rotates.
^
OFF: Deactivate SRRH, depress the brake pedal, and then check that the right rear wheel does not rotate.
(1) Select "SRRH" on the intelligent tester.
(2) Turn the "SRRH" on by the intelligent tester, then depress the brake pedal with stable force.
(3) When the solenoid is on, check the right rear wheel by rotating it by hand.
If the right rear wheel stops, replace the hydraulic brake booster.
HINT:
^
To protect the solenoids, intelligent tester turns off automatically 2 seconds after every solenoid has been turned on.
^
When rotating the wheel fast, the fail-safe function is activated and judgement cannot be made properly. So rotate the wheel as
slowly as possible.
NOTICE: When operating it continuously, set the interval of more than 20 seconds.
(4) When the solenoid is off, depress the brake pedal again and check that the right rear wheel does not rotate by hand.
If the right rear wheel rotates, replace the hydraulic brake booster.
(p) Inspect rear ABS solenoid (SRLH) operation (step L).
HINT:
^
ON: Activate SRLH, depress the brake pedal, and then check that the left rear wheel rotates.
