FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
10. ADJUST VALVE CLEARANCE
11. INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY LH
(a)
Remove any old packing (FIPG) material.
HINT: Do not drop any oil on the contact surfaces of the cylinder head, timing chain cover and cylinder head cover.
(b) Apply a continuous bead of seal packing (diameter 2 to 3 mm (0.08 to 0.12 in.)) to the cylinder head and timing chain cover as shown in the
illustration.
Seal packing: Toyota Genuine Seal Packing Black, Three Bond 1207B or the equivalent
NOTICE: Install the cylinder head cover within 3 minutes of applying the seal packing. Tighten the cylinder head cover bolts and nuts
within 15 minutes of installing the cylinder head cover. Otherwise, the seal packing must be removed and reapplied.
(c)
Install the seal washers onto the bolts.
(d) Install the cylinder head cover with the 10 bolts and 2 nuts. Tighten the bolts and nuts uniformly in several steps.
Torque:
Bolt A 10 N*m (102 kgf*cm, 7.4 ft.*lbf.)
Bolt B 9.0 N*m (92 kgf*cm, 80 in.*lbf.)
Nut 9.0 N*m (92 kgf*cm, 80 in.*lbf.)
HINT: Each bolt length is as follows.
12. INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY
(a)
Remove any old packing (FIPG) material.
HINT: Do not drop any oil on the contact surfaces of the cylinder head, timing chain cover and cylinder head cover.