FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
(a)
While turning the stopper plate of the tensioner upward, push in the plunger of the chain tensioner as shown in the illustration.
(b) While turning the stopper plate of the tensioner downward, insert a bar of diameter 3.5 mm (0.138) into the holes in the stopper plate and
tensioner to fix the stopper plate.
(c)
Remove the 2 bolts, then remove the chain tensioner.
35. REMOVE CHAIN TENSIONER SLIPPER
36. REMOVE IDLE SPROCKET ASSEMBLY
(a)
Using a 10 mm hexagon wrench, remove the No. 2 idle gear shaft, No. 1 idle gear and No. 1 idle gear shaft.
37. REMOVE NO. 2 CHAIN VIBRATION DAMPER
(a)
Remove the 2 No. 2 chain vibration dampers.
38. REMOVE CHAIN SUB-ASSEMBLY
INSTALLATION
1. INSTALL CHAIN TENSIONER SLIPPER
2. INSTALL NO. 1 CHAIN TENSIONER ASSEMBLY
(a)
While turning the stopper plate of the tensioner clockwise, push in the plunger of the tensioner as shown in the illustration.
(b) While turning the stopper plate of the tensioner counterclockwise, insert a bar of diameter 35 mm (0.138 in.) into the holes in the stopper
plate and tensioner to fix the stopper plate.
(c)
Install the chain tensioner with the 2 bolts.
Torque: 10 N*m (102 kgf*cm, 7.4 ft.*lbf.)