FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
/Page-1234001.png)
Control Assembly: Testing and Inspection
INTEGRATION CONTROL AND PANEL
INSPECTION
1. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY
a. Check the blower switch resistance.
1. Using an ohmmeter, measure the resistance and check the results in accordance with the values in the table.
If the result is not as specified, replace the integration control and panel assembly.
b. Inspect the illumination operation.
1. Connect the positive (+) lead from the battery to terminals 1 (IG+) and 2 (ILL+) and the negative (-) lead to terminal 20 (GND), then check
that the illuminations light up.
