FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
/Page-686001.png)
Variable Valve Timing Actuator Position Sensor: Service and Repair
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. DRAIN ENGINE COOLANT
3. REMOVE V-BANK COVER
4. REMOVE AIR CLEANER ASSEMBLY
5. REMOVE VVT SENSOR
a. Bank 1 side VVT sensor:
1. Disconnect the VVT sensor connector.
2. Remove the bolt and VVT sensor.
b. Bank 2 side VVT sensor:
1. Disconnect the No. 4 water by-pass hose and No. 5 water by-pass hose.
2. Disconnect the VVT sensor connector.
3. Remove the bolt and VVT sensor.
INSTALLATION
1. INSTALL VVT SENSOR
