FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
b. Using a screwdriver, remove the occupant classification ECU.
INSTALLATION
1. PRECAUTION
CAUTION: Read PRECAUTION thoroughly before servicing, (Refer to Restraint Systems; Service Precautions).
2. INSTALL OCCUPANT CLASSIFICATION ECU
a. Check that the ignition switch is turned to OFF.
b. Check that the negative (-) battery terminal is disconnected.
CAUTION: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.
c. Install the occupant classification ECU.
d. Connect the 2 connectors to the occupant classification ECU.
NOTE:
-
If the occupant classification ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with