FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
1. CHECK CLUTCH START SYSTEM
(a)
Check that the engine does not start when the clutch pedal is released.
(b) Check that the engine starts when the clutch pedal is fully depressed.
If necessary, replace the clutch start switch assembly.
REMOVAL
1. REMOVE CLUTCH START SWITCH ASSEMBLY
(a)
Disconnect the clutch start switch assembly connector.
(b) Remove the nut and remove the clutch start switch assembly from the clutch pedal support.
INSPECTION
1. INSPECT CLUTCH START SWITCH ASSEMBLY
(a)
Measure the resistance between the terminals when the switch is ON and OFF.