FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
1. DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY
(a)
Fully extend the shock absorber piston rod, and fix it at an angle in a vise or similar tool.
(b) Using a drill or similar tool, slowly make a hole at approximately 50 mm (1.97 in.) from the top end of the shock absorber, and discharge
the gas inside.
CAUTION:
^
The gas is colorless, odorless and harmless.
^
Since the discharged gas may cause chips to scatter, cover the drill with a shop rag or piece of cloth when making the hole.