FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
NOTICE: Immediately wash off any brake fluid that comes into contact with painted surfaces.
3. REMOVE FRONT DISC BRAKE CALIPER ASSEMBLY
4. REMOVE FRONT DISC
5. REMOVE FRONT AXLE HUB BOLT
(a)
Using SST and a screwdriver or the equivalent to hold the axle hub, remove the hub bolt.
SST 09650-17011
INSTALLATION
1. INSTALL FRONT AXLE HUB BOLT
(a)
Install the washer and the nut onto a new hub bolt, as shown in the illustration.
(b) Using a screwdriver or the equivalent to hold the axle hub, install the hub bolt by tightening the nut.
2. INSTALL FRONT DISC
3. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY
4. INSTALL FRONT WHEEL
Torque: 112 N*m (1,137 kgf*cm, 82 ft.*lbf)
5. FILL RESERVOIR WITH BRAKE FLUID
6. BLEED BRAKE LINE
7. CHECK FLUID LEVEL IN RESERVOIR
8. CHECK FOR BRAKE FLUID LEAKAGE