FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
3. Using a scraper, remove any excessive or protruding adhesive.
HINT: Apply adhesive to the rear door glass rim.
NOTICE: Do not drive the vehicle within the time indicated in the table below.
4. CHECK FOR LEAKAGE AND REPAIR
a. Conduct a leak test by applying water to the adhesive portions after the adhesive has completely hardened.
b. Seal any leakage with auto glass sealer.
5. INSTALL ACCESS DOOR GLASS OUTER WEATHERSTRIP
HINT: Use the same procedure as for the RH side.
6. INSTALL REAR DOOR OPENING TRIM
HINT: Use the same procedure as for the RH side.
7. INSTALL CENTER PILLAR UPPER GARNISH
HINT: Use the same procedure as for the RH side.
8. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
HINT: Use the same procedure as for the RH side.
9. INSTALL NO. 1 CUP HOLDER
HINT: Use the same procedure as for the RH side.
10. INSTALL REAR DOOR INSIDE HANDLE SUB-ASSEMBLY
HINT: Use the same procedure as for the RH side.
11. INSTALL LAP BELT OUTER ANCHOR COVER
HINT: Use the same procedure as for the RH side.
12. INSTALL ACCESS PANEL REAR WEATHERSTRIP
HINT: Use the same procedure as for the RH side.