FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
Wiper Motor: Testing and Inspection
Component Inspection
Front Wiper Motor
INSPECTION
1. INSPECT FRONT WIPER MOTOR
a. Check the LO operation.
1. Connect the positive battery (+) lead to terminal 1 (+1) of the connector and the negative battery (-) lead to terminal 5 (E), then check that
the motor operates at low speed (LO).
Standard: Motor operates at low speed (LO).
If the result is not as specified, replace the motor.
b. Check the HI operation.
1. Connect the positive battery (+) lead to terminal 4 (+2) of the connector and the negative battery (-) lead to terminal 5 (E), then check that
the motor operates at high speed (HI).
Standard: Motor operates at high speed (HI).
If the result is not as specified, replace the motor.
c. Check the automatic stop operation.
1. Connect the positive battery (+) lead to terminal 1 (+1) of the connector and the negative battery (-) lead to terminal 5 (E). With the motor
operating at low speed (LO), disconnect terminal 1 (+1) to stop the wiper motor operation at any position other than the automatic stop
position.
2. Using SST, connect terminals 3 (S) and 1 (+1). Connect the positive battery (+) lead to terminal 2 (B) of the connector to restart the motor
operation at low speed (LO).
SST 09843-18040
3. Check that the motor stops automatically in the automatic stop position.
Standard: Refer to the illustration.
If the result is not as specified, replace the motor.
Rear Wiper Motor
INSPECTION