Highlander 2WD L4-2.4L (2AZ-FE) (2001)
License Plate Bracket: Technical Service Bulletins
Front License Plate - Installation
PRODUCT GENERAL INFORMATION
PG025-00
December 1, 2000
Title:
FRONT LICENSE PLATE INSTALLATION
Models:
'01 Highlander
Introduction
The following procedure is recommended for front license plate installation on the 2001 model year Highlander.
Applicable Vehicles
^
2001 model year Highlander vehicles.
Installtion Procedure
1.
Align the installation holes of the front license plate with the dimples on the front bumper.
NOTE:
Do NOT pre-drill holes in the dimples.
2.
Using two self-tapping screws, install the front license plate by directly screwing the self-tapping screws into the dimples.
3.
Use self-tapping screws with the following dimensions:
Nominal Length (L):
20.0 mm (0.79 in.)
Diameter (D):
6.0 mm (0.24 in.)
Warranty Information