Highlander 2WD L4-2.4L (2AZ-FE) (2001)
/Page-1313002.png)
a. Temporarily install the new parts and measure each part in accordance with the body dimension diagram.
HINT: Make sure each measurement is correct, as this parts affects the front wheel alignment.
6. INSTALL FRONT BODY PILLAR LOWER GUSSET
7. INSTALL RADIATOR SIDE SUPPORT
8. INSTALL RADIATOR UPPER SUPPORT
9. MEASURING THE ENGINE COMPARTMENT DIMENSIONS
10. MEASURING THE UNDER BODY DIMENSIONS
11. APPLYING SEALER TO THE ENGINE COMPARTMENT
12. APPLYING SEALER TO THE INSIDE OF THE VEHICLE
13. APPLYING UNDER COATING
14. APPLYING ANTI-RUST AGENT
a. After applying the top coat layer, apply the anti-rust agent to the inside of the necked section structural weld spots.
