Highlander 2WD L4-2.4L (2AZ-FE) (2001)
/Page-905002.png)
1. Using SST, connect the terminals Ts and CG of DLC3.
SST 09843-18040
2. Turn the ignition switch ON.
HINT:
Place the vehicle in a stationary condition with the shift lever in P range.
3. After turning the ignition switch ON, check that the VSC warning light is lit for about 4 sec. and then starts quick blinking at 0.13 sec.
intervals.
4. After ensuring the blinking of the TRAC OFF indicator light for 2 sec., turn the ignition switch OFF.
5. Remove the SST and make the terminals Ts and CG of DLC3 disconnected.
SST 0984-18040
