Highlander 2WD L4-2.4L (2AZ-FE) (2001)
/Page-322013.png)
NOTICE
^
Hold the drill perpendicular to the top surface of the block.
If the bolt holes are drilled at an angle, the cylinder block will need to be replaced.
^
Drill the hole in 4 progressively deeper steps, retracting the drill each time, to clear the cutting particles from the hole.
^
Apply WD-40(R) regularly to lubricate the drill.
C. Remove the core drill and drill bushing.
D. Invert the cylinder block so that it is upside-down.
