Highlander 2WD L4-2.4L (2AZ-FE) (2001)
e. Remove the alternator from SST 2.
f.
Turn SST 1 - B, and remove SST 1 - A, B.
g. Remove the pulley nut and pulley.
2. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY
a. Remove the nut and terminal insulator.
b. Remove the bolt, 3 nuts, plate terminal and end cover.
c. Remove the brush cover.
d. Remove the 2 screws and brush holder.
3. REMOVE GENERATOR REGULATOR ASSEMBLY
a. Remove the 3 screws and voltage regulator.
4. REMOVE GENERATOR HOLDER W/RECTIFIER
a. Remove the 4 screws and rectifier holder.
5. REMOVE ALTERNATOR RECTIFIER END FRAME
a. Remove the rubber insulator.
b. Remove the seal plate.
c. Remove the 4 nuts and cord clip.
d. Using bearing puller set, remove the rectifier end frame.
6. REMOVE GENERATOR ROTOR ASSEMBLY
a. Remove the alternator washer from the rotor.
b. Remove the rotor from drive end frame.
NOTE: Do not drop the rotor.
7. INSPECT GENERATOR ROTOR ASSEMBLY