Highlander 2WD V6-3.0L (1MZ-FE) (2003)
b. Install the tube clamp to the bottom side of the brake actuator bracket with the bolt.
Torque: 5.5 Nm (56 kgf-cm, 49 inch lbs.)
7. INSTALL BRAKE ACTUATOR ASSY
a. Install the 3 cushions and 2 holders to the brake actuator.
b. Install the brake actuator to the bracket with the 2 nuts.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)
8. INSTALL BRAKE ACTUATOR WITH BRACKET
a. Install the brake actuator with the 3 nuts.
Torque: 19 Nm (194 kgf-cm, 14 ft. lbs.)
b. Connect the brake actuator connector.
c. Using SST, connect the 2 brake lines to the master cylinder.
SST 09023-00100
Torque: 15 Nm (155 kgf-cm, 11 ft. lbs.)
d. Using SST, connect the each brake line to the correct position of brake actuator, as shown in the illustration.
SST 09023-00100