Highlander 2WD V6-3.0L (1MZ-FE) (2003)
a. Using SST, hold the crankshaft.
SST 09213-54015 (91651-60855), 09330-00021
b. Clean the bolts and bolt holes.
c. Apply adhesive to 2 or 3 threads of the bolts.
Adhesive: Part No. 08833-00070, THREE BOND 1324 or equivalent
d. Install the front spacer, drive plate and rear spacer on the crankshaft.
e. Install and uniformly tighten the 8 bolts in several passes, in the sequence shown.
Torque: 83 Nm (846 kgf-cm, 61 ft. lbs.)
NOTICE: Do not start the engine within an hour after installing.