Highlander 2WD V6-3.0L (1MZ-FE) (2003)
5. ADJUST TOE-IN (4WD)
a. Measure the distance between each wheel disc and corner of the toe-adjusting cam then confirm that left and right distances are the same.
No. 2 lower suspension arm length difference: 1.0 mm (0.04 inch) or less
If the left-right difference is larger than 1.0 mm (0.04 inch), adjust it by following the procedures.
b. Turn the toe-adjusting cam by an equal amount to adjust toe-in.
HINT:
-
Try to adjust the toe-in to the center value.
-
The toe-in will change by the following specifications corresponding to each graduation of the cam. Approximately 3.3 mm (0.13 inch)
c. Tighten the lock bolt.
Torque: 113 Nm (1,150 kgf-cm, 83 ft. lbs.)
6. INSPECT CAMBER
4WD
2WD
HINT: Camber is not adjustable, if the measurement is not within the specification, inspect the suspension parts for damaged and/or worn-out
parts and replace them as necessary.