Highlander 2WD V6-3.0L (1MZ-FE) (2003)
Oil Filter: Service and Repair
REPLACEMENT
1. REMOVE ENGINE UNDER COVER NO.1
2. REMOVE OIL FILTER SUB-ASSY
a. Using SST, remove the oil filter.
SST 09228-07501
3. INSTALL OIL FILTER SUB-ASSY
a. Check and clean the oil filter installation surface.
b. Apply clean engine oil to the gasket of a new oil filter.
c. Lightly screw the oil filter into place, and tighten it until the gasket contacts the seat.
d. Using SST, tighten it an additional 3/4 turn.
SST 09228-07501
4. ADD ENGINE OIL
5. INSPECT OIL LEAK