Highlander 2WD V6-3.0L (1MZ-FE) (2003)
8. INSPECT BEARING BACKLASH
a. Set a dial indicator near the center of the axle hub and check the backlash in the bearing shaft direction.
Maximum: 0.05 mm (0.0020 inch)
If the backlash exceeds the maximum, replace the axle hub assembly.
9. INSPECT AXLE HUB DEVIATION
a. Using a dial indicator, check the deviation at the surface of the axle hub outside the hub bolt.
Maximum: 0.07 mm (0.0028 inch)
If the backlash exceeds the maximum, replace the axle hub assembly.
10. INSTALL REAR DISC
11. INSTALL REAR DISC BRAKE CALIPER ASSY, LH
a. Install the brake caliper with the 2 bolts.
Torque: 61.8 Nm (630 kgf-cm, 46 ft. lbs.)
b. Install the flexible hose with the bolt.
Torque: 19 Nm (194 kgf-cm, 14 ft. lbs.)
12. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
13. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
14. CHECK ABS SPEED SENSOR SIGNAL