Highlander 2WD V6-3.0L (1MZ-FE) (2003)
14. INSTALL CYLINDER HEAD COVER SUB-ASSY LH
a. Apply seal packing to the cylinder head as shown in the illustration.
Seal packing: Part No. 08826-00080 or equivalent
NOTICE:
-
Remove any oil from the contact surface. Install the cylinder head cover within 3 minutes after applying seal packing.
-
Do not start the engine within 2 hours after installing.
b. Install the cylinder head cover with the 9 bolts. Uniformly tighten the bolts, in several passes.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
15. INSTALL IGNITION COIL ASSY
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
16. INSTALL INTAKE AIR SURGE TANK
a. Using an 8 mm hexagon wrench, install a new gasket and the air intake chamber assembly with the 2 bolts and 2 nuts. Uniformly tighten the
bolts and nuts in several passes.
Torque: 43 Nm (438 kgf-cm, 32 ft. lbs.)
b. Install the No.1 engine hanger with the 2 bolts.
Torque: 39 Nm (400 kgf-cm, 19 ft. lbs.)
c. Install the throttle body bracket with the 2 bolts.
Torque: 20 Nm (199 kgf-cm, 14 ft. lbs.)
17. INSTALL AIR CLEANER ASSEMBLY WITH HOSE
18. CONNECT VACUUM HOSE
19. INSTALL FRONT SUSPENSION BRACE SUB-ASSY UPPER CENTER
Torque: 80 Nm (816 kgf-cm, 59 ft. lbs.)
20. INSTALL V-BANK COVER
21. ADD COOLANT
22. INSPECT FOR ENGINE COOLANT LEAKS