Highlander 2WD V6-3.0L (1MZ-FE) (2003)
/Page-860008.png)
g. Push down the pinion rear.
h. Using snap ring pliers, install a new snap ring.
i.
Put a screwdriver in under the stop collar as shown in the illustration.
j.
Tap the clutch shaft with plastic faced hammer to install the snap ring onto the stop collar.
14. INSTALL STARTER ARMATURE ASSEMBLY
a. Apply grease to the bearings, and install it to the field frame.
15. INSTALL STARTER BRUSH HOLDER ASSY
a. Place the brush holder on the starter yoke.
b. Using a screwdriver, hold the brush spring back, and connect the brush into the brush holder. Connect the 4 brushes.
NOTE: Check that the positive lead wires are not grounded.
16. INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY
