Highlander 2WD V6-3.0L (1MZ-FE) (2003)
/Page-1376003.png)
E.
Remove front door belt molding assembly LH.
a.
Remove the screw.
b.
Put protective tape under the molding (i.e., masking tape, body shop tape).
c.
Using a molding remover or scraper, remove the molding.
2.
Replace Rear Door Molding Assembly LH.
HINT:
^
The installation procedures are the removal procedures in reverse order.
^
Use the same procedures for the RH side and LH side.
NOTE:
Refer to TIS, applicable model year
Highlander Repair Manual:
Engine/Hood: Rear Door:
Overhaul (Highlander).
A.
Remove door pull handle.
B.
Remove rear door trim board sub-assembly LH.
C.
Remove rear door belt molding assembly LH.
a.
Remove the screw.
b. Put protective tape under the molding (i.e., masking tape, body shop tape).
c. Using a molding remover or scraper, remove the molding.
