Highlander 2WD V6-3.3L (3MZ-FE) (2004)
7. REMOVE PARKING BRAKE SHOE ASSY LH NO.1
a. Remove the parking brake shoe hold down spring cup No.1, parking brake shoe hold down spring and parking brake shoe hold down spring
cup No.2.
b. FF: Remove the parking brake shoe hold down spring pin No.1 .
c. Disconnect the parking brake shoe return spring No.2 and remove the parking brake shoe assy LH No.1.
8. REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET
a. Remove the parking brake shoe adjusting screw set.
b. Remove the parking brake shoe return tension spring No.2.
9. REMOVE PARKING BRAKE SHOE ASSY LH NO.2
a. Remove the parking brake shoe hold down spring cup No.1, parking brake shoe hold down spring, parking brake shoe hold down spring cup
No.2 and parking brake shoe hold down spring pin No.2.
b. Remove the parking brake shoe assy LH No.2.
c. Using needle-nose pliers, disconnect the parking brake cable No.3 from the parking brake cable shoe lever.
NOTICE: Be careful not to damage parking brake cable No.3.
10. SEPARATE SPEED SENSOR REAR LH (4WD DRIVE TYPE)
11. REMOVE REAR AXLE SHAFT LH NUT (4WD DRIVE TYPE)
SST 09930-00010
12. REMOVE REAR AXLE HUB & BEARING ASSY LH (4WD DRIVE TYPE)