toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Malfunction Indicator Lamp (MIL)|Page 2572 > < Malfunction Indicator Lamp|Diagrams
Page 1
background image

Malfunction Indicator Lamp: Description and Operation
Malfunction Indicator Lamp (MIL)

MALFUNCTION INDICATOR LAMP

"Check Engine" Light (Malfunction Indicator Lamp)

This lamp comes on when the ignition key is turned to the "ON" position and goes off after the engine starts. This means that the warning light system
is operating properly.

If the lamp remains on, or the lamp comes on while driving, first check the followings.
^  Empty fuel tank. If the fuel tank is empty, refuel immediately.
^  Loose fuel tank cap. If the fuel tank cap is loose, securely tighten it.

These cases are temporary malfunctions. The malfunction indicator lamp will go off after taking several driving trips.

If the lamp will not go off even after the several trips, troubleshoot as directed in Computers and Control Systems and Emission Control Systems.

If the fuel tank is not empty or the fuel tank cap is not loose, there is a problem somewhere in the engine, emission control system, electronic throttle
control system, automatic transmission electrical system or warning light system itself.

Applicable Models
If the engine speed does not increase with the accelerator pedal depressed down, there may be a problem somewhere in your electronic throttle control
system. At this time, vibration may occur. However, if you depress the accelerator pedal more firmly and slowly, you can drive your vehicle at low
speeds. 

Note: Even if the abnormality of the electronic throttle control system is corrected during low speed driving, the system may not be recovered until the
engine is stopped and the ignition key is turned to "ACC" or LOCK" position.

Emissions Inspection and Maintenance (I/M) programs

Your vehicle may not pass a state emission inspection if the malfunction indicator lamp remains on. Check your vehicle's emission control system and
OBD (On-Board Diagnostics) system before taking your vehicle for the inspection.

If either of the following conditions occurs, this indicates a malfunction somewhere in the parts monitored by the warning light system. 
^  The light does not come on when the ignition key is turned to the "ON" position or remains on.
^  The light comes on or flashes while driving.

Malfunction Indicator Lamp (MIL)|Page 2572 > < Malfunction Indicator Lamp|Diagrams