toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Engine Controls - MIL ON/DTC P0346|Page 3483 > < Engine Controls - A/T Downshift Lag/Gear Hunting|Page 3478
Page 1
background image

PROM - Programmable Read Only Memory: Customer Interest
Engine Controls - MIL ON/DTC P0346

ENGINE
EG010-05

Title:
M.I.L. "ON" DTC P0346

Models:
'04 Camry, Highlander & Solara (V6), and
'05 Camry & Solara (V6)

February 18, 2005

Introduction

Under certain driving conditions, some 2004 model year Camry, Highlander, and Solara, and 2005 model year Camry and Solara vehicles equipped with
V6 engines may exhibit a M.I.L. "ON" with the following DTC:

^

P0346 (Camshaft Position Sensor "A" Circuit Range/Performance [Bank 2])

The Engine Control Module (ECM) (SAE term: Powertrain Control Module/PCM) logic has been modified to improve this condition.

NOTE:

^

Version 12.01a or later Diagnostic Tester software is required to perform this procedure.

^

Before proceeding, verify the ECM (PCM) calibration has NOT been updated by checking for the Authorized Modifications Label (shown in
step 1 of the Repair Procedure).

Applicable Vehicles

^

2004 model year Camry, Highlander, and Solara vehicles equipped with V6 engine.

^

2005 model year Camry and Solara vehicles equipped with V6 engine produced BEFORE the Production Change Effective VINs shown below.

Production Change Information

Warranty Information

Applicable Warranty*:
This repair is covered under the Toyota Federal Emissions Warranty. This warranty is in effect for 96 months or 80,000 miles, whichever occurs first,
from the vehicle's in-service date.

* Warranty application is limited to correction of a problem based upon a customer's specific complaint.

Engine Controls - MIL ON/DTC P0346|Page 3483 > < Engine Controls - A/T Downshift Lag/Gear Hunting|Page 3478