Highlander 2WD V6-3.3L (3MZ-FE) (2004)
7. INSPECT MAGNETIC SWITCH ASSY
a. Check the plunger.
1. Push in the plunger and check that it returns quickly to its original position.
If necessary, replace the magnetic switch assy.
b. Check if the pull-in coil has an open circuit.
1. Check the resistance between terminals 50 and C.
Standard: Below 1 ohm
If the result is not as specified, replace the magnetic switch assy.
c. Check if the hold-in coil has an open circuit.
1. Check the resistance between terminal 50 and the switch body.
Standard: Below 2 ohm
If the the result is not as specified, replace the magnetic switch assy.