Highlander 2WD V6-3.3L (3MZ-FE) Hybrid (2006)
2. Keep the vehicle in a stationary condition on a level surface for 2 seconds or more.
3. Check that the ABS and brake control warning lights blink and "CHECK VSC SYSTEM" is displayed on the multi information display
(test mode).
HINT:
-
If the ABS and brake control warning lights do not blink and/or "CHECK VSC SYSTEM" is not displayed on the multi information
display, perform zero point calibration again.
-
The zero point calibration is performed only once after the system enters the test mode.
-
Calibration cannot be performed again until the stored data is cleared once.
c. Turn the ignition switch off and disconnect the SST from the DLC3.