Highlander 2WD V6-3.3L (3MZ-FE) Hybrid (2006)
_hybrid/Page-440001.png)
Variable Valve Timing Actuator Position Sensor: Service and Repair
REMOVAL
1. REMOVE AIR CLEANER CAP W/ INLET
2. REMOVE VVT SENSOR (for Bank 1)
a. Disconnect the VVT sensor (Bank 1) connector.
b. Remove the bolt, and then remove the VVT sensor (Bank 1).
3. REMOVE VVT SENSOR (for Bank 2)
a. Disconnect the heated oxygen sensor connector (Bank 2) from the wire harness bracket.
b. Disconnect the VVT sensor (Bank 2) connector.
c. Remove the bolt, and then remove the VVT sensor (Bank 2).
INSTALLATION
