Highlander 2WD V6-3.3L (3MZ-FE) Hybrid (2006)
Wheel Speed Sensor: Service and Repair
Front Speed Sensor
REMOVAL
1. REMOVE FRONT WHEEL
2. REMOVE FRONT FENDER MUDGUARD SUB-ASSEMBLY
a. Remove the 3 screws, bolt and front fender mudguard sub-assembly.
3. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY
a. Remove the bolts, screws, clips and front fender splash shield sub-assembly.
4. REMOVE FRONT SPEED SENSOR
a. Disconnect the front speed sensor connector.
b. Remove the 2 bolts from the body and the shock absorber assembly.
c. Remove the clamp from the steering knuckle.
d. Remove the bolt and the front speed sensor.
NOTE:
-
Prevent foreign matter from attaching to the sensor tip.
-
Clean the installation hole and the surface for the speed sensor every time the speed sensor is removed.
INSTALLATION