Highlander 2WD V6-3.3L (3MZ-FE) Hybrid (2006)
b. Remove the 2 nuts on the lower side of the front shock absorber.
NOTICE: Keep the bolts inserted.
c. Clean the installation surfaces of the front shock absorber and the steering knuckle.
d. Temporarily install the 2 nuts (Step A).
e. Fully push or pull the front axle hub in the direction of the required adjustment (Step B).
f.
Tighten the nuts.
Torque: 290 Nm (2,960 kgf-cm, 214 ft. lbs.)
NOTICE: Keep the bolts from rotating and tighten the nuts when installing the nuts.
g. Install the front wheel.
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
h. Check the camber.
If the measured value is not within the specification, calculate the required adjustment amount using the formula below.
(Camber adjustment amount) = Specified range medium - measured value
Check the combination of installed bolts. Select appropriate bolts from the table to adjust the camber to the specified value.