Highlander 2WD V6-3.3L (3MZ-FE) Hybrid (2006)
d. Install the 2 nuts to the lower side of rear shock absorber with coil spring.
Torque: 180 Nm (1,840 kgf-cm, 133 ft. lbs.)
NOTICE: When installing the nuts, keep the bolts from rotating.
e. Fully tighten the lock nut.
Torque: 49 Nm (500 kgf-cm, 36 ft. lbs.)
2. CONNECT REAR SPEED SENSOR
a. 2WD: Install the rear brake flexible hose and rear speed sensor wire harness with the 2 bolts. Connect the rear speed sensor connector.
Torque:
5.0 Nm (51 kgf-cm, 44 inch lbs.) (bolt A)
19 Nm (194 kgf-cm, 14 ft. lbs.) (bolt B)
b. 4WD: Install the rear brake flexible hose and rear speed sensor with the 3 bolts.
Torque:
5.0 Nm (51 kgf-cm, 44 inch lbs.) (bolt A)
19 Nm (194 kgf-cm, 14 ft. lbs.) (bolt B)
8.0 Nm (82 kgf-cm, 71 inch lbs.) (bolt C)