Highlander 2WD V6-3.3L (3MZ-FE) Hybrid (2006)
Components
ON-VEHICLE INSPECTION
1. REMOVE FRONT WHEEL
2. REMOVE FRONT DISC BRAKE CALIPER ASSEMBLY
3. REMOVE FRONT DISC
4. INSPECT FRONT AXLE HUB BEARING LOOSENESS
a. Using a dial indicator, check for looseness near the center of the axle hub.
Maximum: 0.05 mm (0.0020 inch)
NOTICE: Ensure that the dial indicator is set at right angles to the measurement surface.
HINT: If looseness exceeds the maximum, replace the bearing.