Highlander 2WD V6-3.3L (3MZ-FE) Hybrid (2006)
a. Remove the drive shaft damper.
8. REMOVE OUTBOARD JOINT BOOT NO.2 CLAMP
a. Using pliers, remove the outboard joint boot No.2 clamp, as shown in the illustration.
9. REMOVE OUTBOARD JOINT BOOT CLAMP
a. Remove the outboard joint boot clamp perform the same procedures as for the outboard joint boot No.2 clamp.
10. REMOVE OUTBOARD JOINT BOOT
a. Remove the outboard joint boot from the outboard joint shaft.
b. Remove the grease from the outboard joint.
11. REMOVE FRONT DRIVE SHAFT LH HOLE SNAP RING
a. Using a screwdriver, remove the front drive shaft LH hole snap ring.
12. REMOVE FRONT DRIVE SHAFT DUST COVER LH
a. Using SST and a press, remove the drive shaft dust cover LH.
SST 09950-00020
NOTICE: Be careful not to drop the inboard joint assembly.
13. REMOVE FRONT DRIVE SHAFT DUST COVER RH
a. Using SST and a press, remove the drive shaft dust cover RH.
SST 09950-00020
NOTICE: Be careful not to drop the inboard joint assembly.