Highlander 2WD V6-3.5L (2GR-FE) (2008)
/Page-2782001.png)
Turn Signal Flasher: Testing and Inspection
LIGHTING: TURN SIGNAL FLASHER ASSEMBLY: INSPECTION
INSPECTION
1. INSPECT TURN SIGNAL FLASHER ASSEMBLY
(a) Disconnect the D12 turn signal flasher assembly connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard voltage:
If the result is not as specified, there is a malfunction on the wire harness side.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:
If the result is not as specified, there is a malfunction on the wire harness side.
(d) Reconnect the D12 turn signal flasher assembly connector.
(e) Measure the voltage according to the value(s) in the table below.
Standard voltage:
