Highlander 2WD V6-3.5L (2GR-FE) (2008)
(a) Remove the 2 bolts and separate the rear disc brake caliper assembly.
NOTE: Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.
3. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY (for 4WD)
(a) Remove the 2 bolts and separate the rear disc brake caliper assembly.
NOTE: Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.
4. REMOVE REAR DISC See: Brakes and Traction Control/Disc Brake System/Service and Repair/Rear Brake/Disassembly
5. REMOVE REAR AXLE HUB BOLT
(a) Temporarily install 2 nuts and 2 washers to the rear axle hub bolt as shown in the illustration.
(b) Using SST and a brass bar or an equivalent tool to hold the hub and bearing assembly, remove the rear axle hub bolt.
SST: 09628-10011
6. INSTALL REAR AXLE HUB BOLT
(a) Install a washer and nut to a new rear axle hub bolt as shown in the illustration.
(b) Using a brass bar or an equivalent tool to hold the hub and bearing assembly, install the rear axle hub bolt by tightening the nut.
7. INSTALL REAR DISC See: Brakes and Traction Control/Disc Brake System/Service and Repair/Rear Brake/Reassembly
8. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY (for 2WD)