Highlander 4WD V6-3.0L (1MZ-FE) (2003)
Bug Guard: All Technical Service Bulletins
Body - Hood Protector Wind Noise
ACCESSORIES
AX005-03
REVISED
November 4, 2003
Title
ACCESSORY HOOD PROTECTOR WITH WEATHERSTRIP
Models
'01 - '04 Highlander
TSB REVISION NOTICE:
December 8, 2003: 2001 - 2003 model years have been added to applicable vehicles. The previous version of this TSB should be discarded.
Introduction
This bulletin addresses wind noise originating from the hood protector area of the Highlander. This is resolved by installing a weatherstrip seal with the
hood protector.
Applicable Vehicles
^
2001 - 2004 model year Highlander vehicles.
Parts Information
Required Tools & Material
Warranty Information
Repair Procedure
1.
Remove screws from current hood protector.
A.
Remove the two middle screws from the hood protector. The two screws are at the locations shown in Figure 1.
B.
Retain the two screws for later use.
2.
Install weatherstrip.