Highlander 4WD V6-3.0L (1MZ-FE) (2003)
a. Install the speed sensor rear LH with the bolt.
Torque: 20 Nm (205 kgf-cm, 15 ft. lbs.)
NOTICE: Do not stick and foreign matter on the sensor tip.
b. Install the sensor harness clamps with the 2 bolts to the body and shock absorber.
Torque: 5.0 Nm (51 kgf-cm, 44 inch lbs.)
c. Push in the sensor wire harness with grommet and connect the speed sensor connector.
7. INSTALL DECK TRIM SIDE PANEL ASSY LH
8. INSTALL REAR FLOOR FINISH PLATE
9. INSTALL REAR DOOR SCUFF PLATE OUTSIDE LH
10. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
11. CHECK ABS SPEED SENSOR SIGNAL