Highlander 4WD V6-3.0L (1MZ-FE) (2003)
Transmission Speed Sensor: Service and Repair
REPLACEMENT
1. REMOVE BATTERY
2. REMOVE AIR CLEANER ASSY
3. REMOVE AIR CLEANER HOSE NO.1
4. REMOVE SPEED SENSOR (NT SENSOR)
a. Disconnect the connector.
b. Remove the bolt and speed sensor.
5. REMOVE SPEED SENSOR (NC SENSOR)
a. Disconnect the connector.
b. Remove the bolt and speed sensor.
6. INSTALL SPEED SENSOR (NC SENSOR)
a. Coat O-ring with ATF.
b. Install the speed sensor with the bolt.
Torque: 11.3 Nm (115 kgf-cm, 8 ft. lbs.)
HINT: Make sure of the manufacturer's name.
c. Connect the connector.
7. INSTALL SPEED SENSOR (NT SENSOR)
a. Coat O-ring with ATF.
b. Install the speed sensor with the bolt.
Torque: 11.3 Nm (115 kgf-cm, 8 ft. lbs.)
HINT: Make sure of the manufacturer's name.