Highlander 4WD V6-3.0L (1MZ-FE) (2003)
b. Using a dial indicator, inspect the front side of the intermediate shaft flange runout.
Maximum runout: 0.1 mm (0.004 inch)
c. Using a dial indicator, inspect the rear side of the intermediate shaft flange runout in the horizontal direction.
Maximum runout: 0.1 mm (0.004 inch)
d. Using a dial indicator, inspect the rear side of the intermediate shaft flange runout in the vertical direction.
Maximum runout: 0.1 mm (0.004 inch)
If the intermediate shaft flange runout exceeds the maximum, replace the intermediate shaft.
7. INSPECT PROPELLER SHAFT
a. Using a dial indicator, inspect the runout of the propeller shaft.
Maximum runout: 0.8 mm (0.031 inch)
If the shaft runout exceeds the maximum, replace the propeller shaft.
8. REMOVE CENTER SUPPORT BEARING ASSY NO.2