Highlander 4WD V6-3.0L (1MZ-FE) (2003)
c. Align the matchmarks on the front flange and shaft and place the flange on the shaft.
d. Using SST to hold the front flange, press the center support bearing assy No.1 into position by tightening down a new nut and plate washer.
SST 09330-00021
Torque: 181 Nm (1,850 kgf-cm, 134 ft. lbs.)
e. Loosen the nut.
f.
Torque the nut again.
Torque: 69 Nm (700 kgf-cm, 51 ft. lbs.)
g. Using a chisel and a hammer, stake the nut.
14. INSTALL CENTER SUPPORT BEARING ASSY NO.2
a. Set the center support bearing assy No.2 on the shaft as shown in the illustration.
b. Install the plate washer to the shaft.
c. Align the matchmarks on the rear flange and shaft and place the flange on the shaft.