Highlander 4WD V6-3.0L (1MZ-FE) (2003)
1.
REMOVE REAR WHEEL.
2.
REMOVE SPEED SENSOR REAR RH (see page 32-46).
3.
REMOVE REAR DRIVE SHAFT ASSEMBLY RH (see page 30-43).
4.
REMOVE STRUT ROD ASSEMBLY REAR (see page 27-11).
5.
SEPARATE REAR SUSPENSION ARM ASSEMBLY NO. 2 RH (see page 27-14).
6.
SEPARATE REAR SUSPENSION ARM ASSEMBLY NO. 1 RH (see page 27-14).
7.
SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY RH.
A.
Remove the 2 bolts and brake caliper.
B.
Support the brake caliper securely.
8.
REMOVE REAR DISC.
9.
REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (see page 33-17).
10.
REMOVE PARKING BRAKE SHOE STRUT COMPRESSION SPRING (see page 33-17).
11.
REMOVE PARKING BRAKE SHOE STRUT RH (see page 33-17).
12.
REMOVE PARKING BRAKE SHOE (see page 33-17).
13.
SEPARATE PARKING BRAKE CABLE ASSEMBLY NO. 3 (see page 33-17).
14.
REMOVE AXLE ASSEMBLY RR RH Remove the 2 bolts, nuts and the rear axle from shock absorber.
15.
REMOVE REAR AXLE SHAFT RH OIL SEAL. Using the SST below, remove the oil seal (inner side).
^
SST 09308-00010
NOTE:
If the oil seal comes off together with the rear axle shaft, remove the oil seal from the shaft.