Highlander 4WD V6-3.0L (1MZ-FE) (2003)
/Page-1403007.png)
3. Using a scraper to remove any excess or protruding adhesive.
HINT: Apply adhesive on the glass rim.
NOTE: Take care not to drive the vehicle during the time described in the table.
29. INSTALL WINDSHIELD MOULDING OUTER UPPER
a. Place new moulding onto the body and tap it by hand.
30. WATER-LEAK CHECK AND REPAIREMENT
a. Conduct a leak test after the hardening time has elapsed.
b. Seal any leak with sealant.
