Highlander 4WD V6-3.0L (1MZ-FE) (2003)
/Page-1417002.png)
9. INSTALL REAR WIPER MOTOR GROMMET
a. As shown in the illustration, install the rear wiper motor grommet with it is position mark upside.
10. INSTALL REAR WIPER ARM ASSEMBLY
a. Clean the rear wiper pivot serration with the wire brush.
b. Stop the rear wiper motor assembly at the automatic stop position. Install the ear wiper arm at the position shown in the illustration.
Torque: 5.5 N.m (56 kgf.cm, 48 in.lbf)
HINT: Hold down the arm hinge with hand to fasten a nut.
c. Operate the rear wiper while running the water or the washer fluid over the rear window, and check the wiping condition and that the rear
wiper does not hit against the vehicle body.
